Looks great Randy; looking forward to you racing 1×1 again!
P.S. If anyone is using the Thunderslot Foam Donuts; the “donut holes” can be trimmed to be used as Wing supports.
— Cut one edge flat; measure wing strut length (appx 4-5mm); cut bottom flat; trim leading and trailing edges with angular cuts. Keep width to match the top (fattest part) of the struts.
— After the angles look good; glue to the inside of the wing struts with a small dab of ShoeGoo.
100% Optional
"... get on your bad motor scooter and ride!"
Sammy with Montrose