Reply To: Q3 Scaleauto Series Discussion

Home Forums Club Races Racing Calendar, Classes & Regulations Q3 Scaleauto Series Discussion Reply To: Q3 Scaleauto Series Discussion

#12227
Avatar photoBarkingSpyder
Participant

    MJK Engineering – Australia
    http://www.armchairracer.com.au/workshop/tyres/mjk-4118-2-x-tyres-to-suit-1-24-scaleauto-porsche-911-gt3
    #MJK-4118 – 2x Rear tyres for 1:24 ScaleAuto Porsche 911 GT3 $6.75/pair/USD
    Supplied on Special Order Request only
    *******
    Mounted Outside Diameter: (A) – 27.5mm
    Mounted Width (B) – 13.0mm
    Rim Diameter (inside) (C) – 21.5mm
    RIB/NIB/NUB Width (F) – 5.0mm
    Wheel Maximum/Outside Rim Diameter (E) – 23.5mm
    Wheel Visible Rim Diameter (D) – 13.0mm

    Attachments:

    "... get on your bad motor scooter and ride!"
    Sammy with Montrose

    Avatar photo

    BarkingSpyder

    At 4-years old in Pensacola I repaired my steering linkage on my Ford Pedal-car. Dad later converted this car to a Blue Angel with ailerons and elevators with a working "stick/yoke"; the rudder was controlled by the steering wheel. I like all motorsports - I grew up going to a NASCAR Feeder track with Sportsman and Modified classes, and was lucky to attend drag races in 1970 at Orange County Raceway. My first solder-iron was a Christmas gift at 9yo; I modified T-Jets to be AFX spec before AFX Cars were in local stores. I rebuilt a few tractor & car (SIMCA) engines plus transmissions by 15yo (I still have my ring-compressor and valve spring tool) I am a former mountain and road bike geek & perennial sound engineer. Struggling guitar hobbyist and Amp "tweeker"