Slot.it Challenge – Clerk of the Course Procedures

Home Forums Club Races Racing Calendar, Classes & Regulations Slot.it Challenge – Clerk of the Course Procedures

Viewing 0 reply threads
  • Author
    Posts
    • #224
      Avatar photoAutorama
      Keymaster

      Slot.it Challenge
      Clerk of the Course

      Procedures before race:

      Cars should have their body detached from the chassis when presented for inspection.
      Collect race entry fee.

      General:
      • Models allowed: Sauber C9 Mercedes, Jaguar XJR9 & XJR12, Lancia LC2, Mazda 787B, Porsche 956/962.
      • Log car weight and magnetic pull using a Magnet Marshal.

      Body:
      • Check for any modifications to body or cockpit, weight removal in particular.
      • Verify spoiler rigidity.

      Chassis:
      • Check for any modifications to the chassis. Chassis must be intact and not over sanded.
      • Check lead wires interference with front axle ride height.
      • Check for magnets.
      • Verify that tires do not protrude outside the body.
      —– A strip of plastic will be provided for this verification. Place the plastic strip against the body and verify that the tires do not touch it.
      • Verify that the motor pod does not protrude below the chassis.
      —– A strip of plastic will be provided for this verification. Place the plastic strip against the chassis and verify that the pod is level or above it.

      Motor:
      • Check for any modification to the motor.
      • Check motor serial number and tamper proof seal condition. Motor serial number most match with the number draw by the racer from race 1 to 3 and from race 4 to 6.
      —– Log motor serial number.

      Motor Pod:
      • Check for any modification to the motor pod.
      • Check for excessive flash removal.
      • Check for the use of spacers between motor pod and chassis.

      Gears:
      • Check for any modification to the gears.

      Wheels:
      • Check for any modifications to the wheels.
      • Check wheel size/diameter.

      Tires:
      • Check if tires were glued
      —– Lift tire slightly but do not remove it.
      • Check for the presence of traction compounds
      • Verify tire brand

      Ask the participant to attach the body and tape over all screws.

      Chassis:
      • Verify that tape used over screws do not interfere with pod movement.
      _____________________________________________________________________________

      Procedures during race:
      All work to a car must be done during green flag conditions.
      _____________________________________________________________________________

      Procedures after race:
      If a car had work done during a race, verify the car for any irregularities listed on the “procedures before race”.
      _____________________________________________________________________________

Viewing 0 reply threads
  • You must be logged in to reply to this topic.