I have left a supply of Thunderslot tires (not legal for racing, but good for practice) in the club room on the same shelf as the power supplies. Please help yourself but don’t be piggy, and please let me know when supplies run low.
Along with the tires, are some mounting supplies. Some measuring cups, stirrers, and toothpicks for application of glue.
The glue is Smooth-On Ure-Bond III a two part flexible urethane adhesive. It has a pot life of 5-10 minutes, depending on temperature, and a cure time of 24 hours. Mix is 1:1 by volume. I have been using the mixing cups to pour out 5ml of each, which is a lot for a couple tires, but any less and it might be tough to get proportions right. You can always try blobbing out a bit of A and B on a card, or other clean surface like you would epoxy. Like epoxy one of the components is more viscous than the other, just something to be aware of.
Once you mix, the clock is ticking, so make sure you have everything prepared in advance.
Uncured glue can be cleaned up with isopropyl alcohol. Once it’s cured it can be a bear to remove. so prepare a work area with some newspaper or similar.
-Marc T.
"Enjoy every sandwich"
-Warren Zevon