POSTED FOR RUSSELL
Some comments:
I like Ary’s idea of individual voltage controllers. This would be especially good for series with a spec motor. The master voltage could be set to 11.5V or 12V to allow just a little variation for voltage, up to 15V for quite a lot. For Steve’s Prototype/GT series, the GT cars could be set to a fixed, lower voltage.
I am opposed to any series requiring stock plastic wheels. A spec wheel could be required, if necessary.
I realize that the goal for series discussion and preliminary voting was to weed out less popular options to make the often long-winded discussion at the annual meeting more manageable, but I would hesitate to say that only the top six would be considered. There are too many variables on rules that would make some series more or less popular. Cases could be made at the meeting for particular rules that would make a low-ranking series much more palatable. We could probably eliminate those that are at the bottom of the preliminary voting.
If the Can Am series is voted in, I would like to see an open format. Simply requiring a maximum wheel width of 12mm would eliminate any, ahem….., creative wheel construction. I don’t think it would be necessary to require F1 wheels, as they would be hard to find inserts for. Wheel diameter would be open as a wide variety of wheels were used. The F1 20 X 12 F22 Raptor tires will fit a standard wheel. I think the only other rule requirement would be to disallow any 1:30 or larger cars. Tires and wheels must fit within the body width.
IMHO
Russell