**DRAFT**
Slot It Models Allowed
Alfa Romeo 155 V6Ti
Mercedes 190E
Mercedes C-Class
Opel Calibra
Body
Modifications prohibited (except as follows)
OEM hard cockpits and Glass mandatory; Lexan cockpits prohibited.
Body must start every race with all major parts intact (e.g. windows and wings). Antennas, mirrors, wipers, tow hooks, and other small parts damaged from accidents do not have to be replaced.
Wings mandatory during green flag. Wing repairs must occur during green flag. Wings not replaced before end of the heat incur 10 lap penalty. Wing’s lost or damaged in last lap do not incur a penalty.
White kits allowed – but must be painted (or decaled uniquely) with at least one coat of paint. At least two numbers must be visible.
Body screws open choice. Optionally taped to prevent loss. If a screw falls off the car and causes an issue with a competitor’s car, Five lap penalty applied.
Chassis
No modifications to chassis allowed unless otherwise specified.
Only the stock OEM Slot.It chassis for the mode is allowed.
Chassis must be of type intended for body.
Only flashing on chassis may be removed to allow better floating of the body. Excessive removal determined by scruitineer.
Front axle lower adjustment caps allowed. Modification to the upper axle loops is prohibited.
Slot It bushings are allowed for the front axle.
Slot.It guides mandatory – SICH-07 deep wood screw guide highly recommended.
Pick-up braids open choice.
Traction magnets prohibited.
Ballast allowed; must must be above the chassis pan. 5 lap penalty will be imposed if ballast falls onto track and causes an issue with a competitor’s car.
Lead wires – free choice.
Wheel/tire must not we visible outside wheel-well/fender when viewed from above.
Motor
The stock Slot.It 21K (black end-bell) motors mandatory.
Modifications to motor are prohibited with the exception of removal of the circuit board on top of the motor.
Motor Pod
Only the stock CH-110 OEM motor pod is allowed.
Motor pod prohibited from protruding below chassis.
Only flashing may be removed from motor pod to allow better float. Excessive removal of material determined by scrutineer.
Spacers/washers open choice.
Slot.it spherical bushings mandatory.
Tape may be used to prevent the Pod Screws from falling out.
Gears
Slot.It gears and pinions mandatory.
Gear Ratio open-choice.
Modifications to Crowns or Pinions prohibited
Wheels
Only the stock Slot.it short hub aluminum 15.8 x 8.2 wheels allowed on the rear. Front wheels must be stock 15.8 x 8.2 plastic or the aluminum versions of the same dimension.
Slot.it DTM wheel inserts are mandatory.
Inserts may be interchanged from different models.
Modifications prohibited.
Axles
Only Slot.It axles allowed. Modifications to axles prohibited.
Tires
Only Slot.It tires are allowed.
Tires may be glued to the wheels, trued and have their edges rounded.
Traction compounds prohibited.
Nail polish on front tires is prohibited.
Zero-Grip (front) F30 (rear) tires highly recommended.
Track Power: 12v
General
If it is not mentioned it is not legal. These rules were written to create a fair event and not for racers to look for loopholes.
